Skip Navigation Website Accessibility
 


(USED) Sunn Beta Lead Combo Amp - Vintage 100W Solid-State Guitar Combo with Original Footswitch - A89064

Sunn Beta Lead Combo Amp – Used Vintage 100W Solid-State Guitar Combo – A89064

The Sunn Beta Lead is the solid-state amp that players seek out on purpose. Its CMOS drive circuit goes from a clear, punchy clean to a thick, fuzz-like distortion that cleans back up when you roll off your guitar’s volume. This is an original vintage 100-watt combo, serial number A89064, with two full channels you can play one at a time or stack together.

It suits guitarists chasing heavy, saturated tones for doom, sludge, stoner rock and loud alternative, and it works just as well as a big clean platform for pedals. This used example comes with its original Sunn footswitch, which is the part most often missing from these amps. Call or text Spotts Music Center at 814-371-5666 with any questions about this particular amp.

Key Features

CMOS Drive Circuit

Turn up the Drive for the thick, fuzz-like distortion the Beta Lead is known for, then clean it up from your guitar’s volume knob.

Two Independent Channels

Each channel has its own Drive, Bass, Mid, Treble, Reverb and Level, so your clean and dirty sounds are set separately.

Blend Both Channels

The Both input runs channels A and B together for a layered tone that neither channel makes on its own.

100 Watts, Solid-State

Plenty of volume to keep up with a loud drummer, with no power tubes to wear out or replace.

Three Effects Loops

A loop on each channel plus a master loop lets you place effects on one sound only or across the whole amp.

Original Footswitch Included

The original Sunn footswitch lets you change channels from the floor instead of re-plugging between songs.

How to Use the Beta Lead’s Two Channels

  1. Start with the Master volume low, then plug into the Channel A or Channel B input to play through that channel on its own. Its indicator light comes on.
  2. Plug into the Both input instead to feed both channels at once. Both indicator lights come on.
  3. Connect the original footswitch to the footswitch jack. With your guitar in the Both input, use it to select channel A, channel B or both together.
  4. Set Drive and Level on each channel so they balance against each other, then bring up the Master to set your overall volume.

Care Tip: Keep the original footswitch with the amp and coil its cable loosely rather than wrapping it tight. It uses a dedicated multi-pin connector, so a standard amp footswitch will not work in its place and original replacements are hard to find.