(USED) Rowin Noise Gate - Compact Noise Reduction Pedal
|
|
|
|
Rowin Noise Gate – Compact Noise Reduction Pedal
This Rowin noise gate is a small, metal-shell pedal that cuts hiss and hum from your signal chain without coloring your tone when it’s off. A single threshold knob controls how aggressively it gates, and a Hard/Soft switch lets you match the response to your setup — Hard for taming high-gain distortion, Soft for a gentler touch with lower-gain overdrive or single-coil pickups.
It’s a practical, budget-friendly add for anyone dealing with noisy pickups, high-gain amps, or a chain of gain pedals that hiss between notes — small enough to tuck onto a crowded board without eating up real estate.
Key Features
Hard/Soft Gate Modes
A toggle switch selects an aggressive Hard gate for high-gain rigs or a gentler Soft gate that preserves natural decay.
Single Threshold Control
One knob sets how much noise reduction is applied, keeping setup quick and uncomplicated.
True Bypass
Keeps your signal unaffected when the pedal is switched off, with no tonal coloration.
LED Status Indicator
A clear LED shows at a glance whether the gate is engaged or bypassed.
Compact Metal Housing
A small, durable metal shell means it fits on a crowded board without taking up much space.
Standard 9V DC Power
Runs on a standard 9V DC, center-negative power supply, the same as most pedalboard power bricks.
Care Tip: Place this gate at the front of your signal chain, before your gain pedals, for the most effective noise reduction — and start with the threshold low, raising it gradually, since setting it too aggressively can cut off the natural decay of your notes.