(USED) Peavey PVXP-12 Powered Speaker
(USED) Peavey PVXp 12 – 800W Powered PA Speaker
The original Peavey PVXp 12 is a two-way, bi-amped powered PA speaker with an 800-watt peak amplifier split between a 12-inch Peavey Pro-12 woofer and an RX14 compression driver with a 1.4-inch titanium diaphragm. The horn is an asymmetrical Quadratic Throat waveguide with 100 by 50 degree coverage that aims the sound 10 degrees downward, so more of your mix lands on the audience and less bounces off the ceiling. Peavey’s DDT compression watches the amp and steps in before clipping can damage the drivers.
It suits working bands, DJs, churches, schools and anyone who needs a rugged box that can go on a pole for mains or lie on its angled side as a floor monitor. The molded cabinet has three built-in handles and a powder-coated steel grille, and a rear expansion bay accepts Peavey’s optional mixer and EQ modules. This is a used unit — call or text 814-371-5666 for details on cosmetic condition and what is included.
Key Features
Asymmetrical Quadratic Throat Horn
The 100 by 50 degree waveguide aims the high end 10 degrees downward toward listeners, cutting ceiling reflections and giving you more gain before feedback.
800 Watts Peak, Bi-Amped
Separate amplifiers feed the woofer and compression driver, so the low end and the vocals never fight each other for power.
Heavy-Duty Driver Set
A 12-inch Pro-12 woofer with a 2-3/8-inch voice coil and 50-ounce magnet handles the lows, while the RX14 titanium compression driver keeps the highs clean at volume.
DDT Speaker Protection
Peavey’s Distortion Detection Technique senses the onset of clipping and compresses the signal so an overdriven input does not take out a driver.
Combo Input and Thru Outputs
The combo jack takes a mic on XLR or a line signal on 1/4-inch TRS, and XLR plus 1/4-inch thru outputs pass the signal on to a second speaker or a subwoofer.
Pole, Fly or Floor Monitor
A 35mm pole socket, M10 flying inserts and an angled side for wedge use mean one box covers mains, monitors and installed jobs.
How to Set Up
- Mount the speaker on a 35mm speaker pole for mains, or lay it on its angled side as a floor monitor with the horn pointed at the performer.
- With the speaker switched off and its level turned down, connect your source. A microphone goes into the XLR side of the combo jack; a mixer or line-level source goes into the 1/4-inch TRS side.
- Power on the speaker, bring your source up to its normal working level, then raise the speaker level until the room is covered. If the sound starts to flatten or squash, the DDT protection is working hard — back the level down a touch.
- To add a second speaker or a subwoofer, run a cable from the XLR or 1/4-inch thru output on the back panel to the next box.
- Press the recessed contour switch in for background music at low volume, where it boosts the highs and lows; leave it out for a live mix at full level.
Care Tip: Power the PVXp 12 on last and off first in your rig so turn-on thumps from the mixer never reach the drivers, and keep the rear vents clear of dust and spilled drinks — the cooling fan pulls air straight through them and onto the amplifier board.